The SEAL PLUG FEEDER above was designed for manual operation and was built for use with connectors that require seal plugs where pins are not connected to wires. The operator inserts the seal plug nose into the connectors holes where a seal plug is needed. They then pull the trigger and a seal plug is put into the hole and pushed in. An additional unit can feed the contacts prior to feeding the seal plug. Each unit is designed to feed one seal plug. Some may interchange if similar is size and shape. Light weight, easy to use. Runs at about 1.5 seconds per cycle (depending on the operators speed). This unit starts at $7,495.00 ea.
A dual bowl unit is also available to feed the contact in one bowl and the seal Plug in the other bowl. Just flip the switch back and forth between them. There is also an X Y table feeder. Just place the connector in a holder, teach the unit which holes get a seal plug and it will keep doing the same program over and over. Save each program for future use.
C. Davis Systems is a full turnkey Automation house. If you have a special need or function you need any one of our machines to do, or any area of bottle neck in your production line, just ask and we can design a machine just for your application.
Contact us for a quote to feed your Seal Plug or application
AT: